A Non-Gypsum Waterproof Drywall Replacement System for Flood-Prone Areas
The EnduraFlood BASE-KLIP is a waterproof mounting clip engineered for use with the EnduraFlood flood-resistant wall system in areas exposed to flooding, storm surge, and high water conditions. Unlike traditional mounting hardware that can corrode and fail when wet, BASE-KLIP is manufactured from a 100% waterproof inorganic polymer composite that will not absorb water, swell, deteriorate, or support mold growth.
Designed specifically as part of the EnduraFlood waterproof drywall system, BASE-KLIP mounts to 1-1/2" wide wooden and metal studs and supports ENDU-BOARD or cement wall panels from below. The proprietary "No-Twist Wings" keep BASE-KLIP from spinning while the screw is tightened.
Why Choose BASE-KLIP Instead of Traditional Mounting Hardware?
Standard mounting hardware is vulnerable to water damage. Even minimal exposure can result in corrosion, weakening, and conditions that compromise wall panel stability. BASE-KLIP offers a true waterproof mounting clip solution designed for:
- Basements
- Coastal homes
- Flood zones
- Hurricane-prone regions
- Post-disaster rebuilding projects
Because it is manufactured from a 100% waterproof inorganic polymer composite, BASE-KLIP will not deteriorate after direct water exposure. After a flood event, the clip remains intact, helping simplify drying and recovery. BASE-KLIP is also 100% saltwater proof.
Key Features
100% Waterproof Construction: Built for direct water exposure
Non-Gypsum, Inorganic Material: Will not rot, swell, or degrade
Mold-Resistant Composition: Inhibits microbial growth
Durable & Lightweight: Strong yet easier to handle than traditional materials
Designed for the EnduraFlood System: Integrates with related components for a complete flood-ready wall assembly
Ideal Applications
Residential flood protection upgrades
FEMA compliance improvements
Hurricane and coastal rebuilding
Basement finishing in high-water-table regions
EnduraFlood BASE-KLIP, Box of 50
Before installing BASE-KLIP, temporarily hold the wall panel in place using hand lifts. To install BASE-KLIP, slide between wall panel and stud, so that the tounge supports the wall panel. The 3/16" mounting hole of BASE-KLIP should be below the panel.
Use TH-SCREW (for wooden stud) or SD-SCREW (for metal stud) to screw BASE-KLIP onto the stud.
For step-by-step video guides, visit our Installation Videos page: https://www.enduraflood.com/installation-videos
